PREPARACIÓN DE SU BARRIL REFRIGERADOR
INSTRUCCIONES
DE ARMADO
1. Instalación de la barandilla: Instale los dos rieles cromados
usando un destornillador Phillips #2 y los cuatro tornillos
autorroscantes incluidos, tal como se indica en la Fig. 1.
2. Instalación del regulador de CO2: Fije el regulador de CO
2
al
cilindro de CO
2
atornillando la tuerca del regulador en la
válvula del cilindro y ajustándolo con una llave ajustable.
Ver Fig. 2
3. Instalación del cilindro de CO
2
: Coloque su cilindro cargado
de CO
2
sobre el soporte.
NO
TA IMPORTANTE: TENGA SIEMPRE MUCHO CUIDADO AL
MANIPULAR CILINDROS CARGADOS DE CO2.
4. Instalación del soporte de cilindro de CO2: . Alinee los orificios
del soporte del cilindro con los tachones y presione firmemente.
Ver Fig. 3
50
SETTING UP YOUR KEG COOLER
13
1. Unplug the keg cooler and
place the unit on its back..
2. Remove the kickplate by
removing the three retaining
screws (Fig. E1)
3. Remove the four screws
from the lower support
(
Fig.E2) and remove the
lower support.
4. Pull the door downward until
it releases from the upper
hinge pin.
5. Remove the plastic screw
caps from the top left hand
side and install it on the top
right hand side of the door
frame.
6 Unscrew the upper door
hinge pin (Fig E3) from the
right side of the worktop
and install it on the left side
of the worktop.
7. Position the main door on
the cabinet and push up
until the upper hinge pin is
inserted into the top of the
door.
8. Remove the lower support
pin from the lower support
and reposition it as shown
in Fig. E4).
9. Reinstall the
lower support pin on
the lower right side of
the door.
10. Make sure to align the door
with 1) the cabinet, and 2)
the lower support pin before
reinstalling the bottom-plate
and its four (4) screws.
11. Reinstall the kick-plate.
IMPORTANT!
Allow the unit to stand upright
for 1 hour before putting the
unit into operation.
WARNING!
Excessive Weight Hazard
Use two or more people to
move and install the keg
cooler.
Changing Direction
of the Door “Swing”
IMPORTANT NOTICE: Before proceeding with the configuration
options on this page, remove keg and the CO
2 cylinder (if installed)
from the Keg Cooler. Once complete, allow the unit to stand
upright for 1 hour before putting the unit into operation.
TOOLS REQUIRED: Phillips #2 screwdriver
Fig. E3
Fig. E2
Fig. E1
Fig. E4
Fig. 2
Castor Installation
1. Lay the unit on it’s back.
2. Using the 16 machine screws
provided, install each of the 4
castors in the threaded holes
located in each corner of the
unit as shown in Fig.A.
Fig. A
The locking swivel castors
should be installed in the
front of the unit for easy
access.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais